10
9
10
Avoid pinching the
Main Wire (110)
7
10. Untie and discard the wire tie on the Main
Wire (110).
While a second person holds the Console (7)
near the Upright (4), plug the Main Wire (110)
into the receptacle on the Console.
The connector on the Main Wire (110) should
slide easily into the receptacle and snap into
place. If the connector does not slide easily into
a receptacle, turn the connector and try again. If
you do not connect the connector properly,
the Console (7) may become damaged when
you use the elliptical.
Insert the excess wire into the Upright (4) or into
the Console (7).
Tip: Avoid pinching the Main Wire (110).
Attach the Console (7) to the Upright (4) with
four M4 x 16mm Screws (101); start all the
Screws, and then tighten them.
101
82 14
60
64 Grease
58
4
110
101
9. Apply grease to one of the Pedal Arm Axles (64).
Next, slide an M8 x 22mm Washer (14) onto an
M8 x 12mm Screw (82), and tighten the Screw a
few turns into the Pedal Arm Axle (64).
While a second person holds the front end of the
Right Pedal Arm (58) inside the bracket on the
Right Upper Body Leg (60), insert the Pedal Arm
Axle (64) into both parts.
Next, slide an M8 x 22mm Washer (14) onto
another M8 x 12mm Screw (82), and tighten the
Screw a few turns into the Pedal Arm Axle (64).
Then, tighten both Screws at the same time.
Repeat this step on the other side of the
elliptical.
82
14
