ASSEMBLY
Assembly requires two people.
Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the parts
used in assembly.
Assembly requires the following tools: The included allen wrench and your own
phillips screwdriver and adjustable wrench .
1. With the help of a second person,
carefully
lay the
treadmill on its right side. Insert one of the Extension
Legs (41) into the treadmill as shown. Make sure that the
Base Pad (36) is on the indicated side. Attach the
Extension Leg with an Extension Leg Screw (34). Be
sure to push on the head of the Extension Leg Screw
while tightening it.
Attach the other Extension Leg (41) as described above.
With the help of a second person,
carefully
raise the
treadmill to the upright position so the Extension Legs
(41) are resting flat on the floor.
2. Refer to HOW TO LOWER THE TREADMILL FOR USE
on page 11. Follow the instructions in step 2 to lower the
treadmill.
Position one of the Handrails (2) on the left Upright (14)
as shown. Thread a Handrail Bolt (15) with a Handrail
Washer (16) into the left Upright and the Handrail.
Do not
tighten the Handrail Bolt yet.
Tighten a Handrail Screw
(32) into the lower end of the Handrail. Be sure to push
on the head of the Handrail Screw while tightening it.
Next, tighten the Handrail Bolt (15).
15
16
14
32
2
2
Handrail Washer (16)–2
Handrail Bolt (15)–2
Base Screw/Latch Screw (13)–6
Extension Leg Screw (34)–2
Handrail Screw (32)–2
34
34
41
36
41
36
1
