6
3. With the help of a second person, hold the Console Base
(6) and the other Handrail (2) near the right Upright (14)
as shown. Note: It may be helpful to rest the other side of
the Console Base on the left Handrail.
Connect the Console Wire Harness (88) to the two plugs
on the Upright Wire Harness (26). Refer to the upper
inset drawing. Locate the 7 1/2” Wire Ties (10) on the
Console Wire Harness (88) and the Upright Wire Harness
(26). Slide the Wire Ties against the plugs as shown.
Insert the 11 1/2” Wire Tie (55) through the holes in the
Wire Ties. Close and tighten the 11 1/2” Wire Tie.
Refer to the lower inset drawing. Insert the Wire
Harnesses (26, 88) into the Right Upright (14). Note: If
necessary, bend the Wire Harnesses into an “s” shape.
Route the Console Wire Harness (88) through the notch
in the bracket on the right Handrail (2) as shown. Insert
the bracket into the right Upright (14).
Make sure that the
Console Wire Harness is not pinched.
4. Thread a Handrail Bolt (15) with a Handrail Washer (16)
into the right Upright (14) and the right Handrail (2).
Do
not tighten the Handrail Bolt yet.
Tighten a Handrail
Screw (32) into the lower end of the Handrail. Be sure to
push on the head of the Handrail Screw while tightening
it. Next, tighten the Handrail Bolt (15).
Place the Console Base (6) on the left and right Handrails
(2). Attach the Console Base with four Console Screws
(13).
5. Attach the Storage Latch (12) to the left Upright (14) with
two Latch Screws (13). Be careful not to overtighten the
Latch Screws.
6. Remove the backing from the Adhesive Clip (74). Press
the Adhesive Clip onto the Upright Base (14) in the indi-
cated location. Press the Allen Wrench (73) into the
Adhesive Clip.
7.
Make sure that all parts are tightened before you use
the treadmill. Note: To protect the floor or carpet,
place a mat under the treadmill.
13
6
13
15
16
14
2
32
4
13
12
14
5
73
74
14
6
2
14
3
6
26
10
10
55
88
88
Notch
26
26
88
14
2
