4
ASSEMBLy
1.
Connect the wire coming out from the upright as
shown on picture 1.
2.
Place the upright in its base as shown picture 2.
3.
With the 6 M8 screws, fix the upright to the base. Do
not tighten these screws at this stage. After they are all in
place then tighten correctly.
4.
Insert the arm on the upright. Than place the protec-
tion washer as shown on picture 4.
5.
With the 4 M6 screws, fix the protection washer to the
upright. Take care to add the washer M6 to the screw first.
Do not tighten these screws at this stage. After they are all
in place then tighten correctly.
