6
STEP 1
Install the Front stabilizer (2) and Rear stabilizer
(3) to the Main frame (1) and fixing with the Square
neck bolt (13), Arc washers (14) and Acorn nut
(15).
STEP 2
While another person holds the Upright (4) near
the Frame (1), connect the Extension Wire (21) to
the sensor Wire (16).
Next, connect the Resistance Cable (8) to the Low-
er Cable (17) in the following way:
• See drawing A. Pull upward on the metal bracket
on the Lower Cable (17), and insert the tip of the
Resistance Cable (8) into the wire clip inside the
metal bracket as shown.
• See drawing B. Firmly pull the Resistance Cable
(17) upward and slide it into the top of the metal
bracket as shown.
• See drawing C. Using pliers, squeeze the prongs
on the upper end of the metal bracket together.
Push the Wires (21,16) and the Cables (17, 8)
downward into the Frame (1).
Tip: Do not pinch the wires and cables. Insert the
Upright (4) into the Frame (1). Attach the Upright
with three Screws (18) and three Washers (14).
STEP 3
Put the Pulse wire (27) through the hole of Front
vertical tube (4), then pull out to the top of the Front
vertical tube (4).
Assemble the Handle bar (5) to the Front vertical
tube (4) fixing with Bolts(23) and Spring washers
(22).Finally put on the Handle cover (24) to the
handle bar
A
B
C
9
6
6
9
8
17
17
8
Metallic
support
Metallic
support
