8
HOW TO ADJUST THE HEIGHT AND THE LATERAL
POSITION OF THE SEAT
For effective exercise,
the seat should be at the
proper height. As you
pedal, there should be a
slight bend in your knees
when the pedals are in
the lowest position. To
adjust the height of the
seat, first loosen the seat
post knob. Next, pull the
knob, slide the seat post
upward or downward to the desired position, and
then release the knob. Move the seat post upward
or downward slightly to make sure that the knob is
engaged in one of the adjustment holes in the seat
post. Then, tighten the knob.
To adjust the lateral position of the seat, first loosen
the seat knob a few turns. Then, move the seat
forward or backward to the desired position, and
firmly tighten the seat knob
HOW TO ADJUST THE ANGLE OF THE
HANDLEBAR
To adjust the angle
of the handlebar,
loosen the pivot handle,
rotate the handlebar
to the desired
angle, and then
retighten the pivot
handle.
HOW TO ADJUST THE PEDAL STRAPS
To adjust the pedal straps, first pull the ends of the
pedal straps off the tabs on the pedals.
Adjust the pedal
straps to the desired
position, and then
press the ends of the
pedal straps onto the
tabs.
HOW TO PLUG IN THE POWER ADAPTER
IMPORTANT: If the exercise bike has been exposed
to cold temperatures, allow it to warm to room
temperature before plugging in the power adapter.
If you do not do this, you may damage the console
displays or other electronic components.
Plug the power adapter into the receptacle on the
frame of the exercise bike.
Next, plug the power adapter into the plug adapter.
Then, plug the
plug adapter into
an appropriate
outlet that is
properly
installed in
accordance with
all local codes
and ordinances.
HOW TO OPERATE THE EXERCISE CYCLE
Pedal
Strap
Knob
Measure your heart rate if desired.
You can measure you heart rate using the handgrip
pulse sensor.
If there are sheets of plastic on the metal contacts
on the handgrip pulse sensor, remove the plastic.
In addition, make sure that your hands are clean.
To measure your heart rate, hold the handgrip pulse
sensor with your palms resting against the metal
contacts. Avoid moving your hands or gripping the
contacts tightly.
When your pulse is detected, your heart rate will
be shown in the display. For the most accurate
heart rate reading, hold the contacts for at least 15
seconds.
If your heart rate is not shown, make sure that
your hands are positioned as described.
Be careful not to move your hands excessively or to
squeeze the metal contacts tightly. For optimal
performance, clean the metal contacts using a soft
cloth; never use alcohol, abrasives, or chemicals
to clean the contacts.
HOW TO MESURE YOUR HEART RATE
Contact
Power
Adaptor
Electric
UK
adaptor
