Pro-Form PFSB63131, User Manual

9

5. Make sure that a qualified electrician has wired the

spa to a 240 volt power source.  

Remove the two warning decals (see page 5) from
the spa shell. Using a damp cloth, wipe the spa shell
clean. Before filling the spa, make sure that it is
in the desired position and that there is room to
easily service it. Once the spa is filled, it will
have to be drained before it can be moved.

Insert a garden hose into the filter housing, and
begin filling the spa. Do not use soft water. The
spa may be filled with cold water; however, if warm
or hot water is used, the spa will be ready for use
sooner. Fill the spa until the water is at the level of
the molded fill line. Do not overfill the spa.

See the inset drawing. Set the Filter (5) and the
Basket (22) into the filter housing. Next, place the
Filter Cover (3) into the filter housing until it is fully
seated.

3. Insert the Pillow (38) into the lounge seat recepta-

cle. Note: Rotate the Pillow 180º to change
between the high and low positions.

4. The spa should be located near a power source capable of supplying 240 volts AC power. It must be wired

directly into a grounded circuit with a 45 amp circuit breaker and a Ground Fault Circuit Interrupter (GFCI)
capable of carrying 45 amps. No other appliance should be on the same circuit. This procedure must be
performed by a qualified, licensed electrician. A wiring diagram is found on the inside of the controller
for reference. Under no circumstances should the spa be wired by someone other than a qualified
electrician. Before you have the spa wired, make sure it is in the desired position, and that it can be easily
serviced, if needed.

6. Pull down one of the straps on the Spa Cover (11)

and hold the Buckle (26) against one of the panels
on the spa. (Note: To position the Buckle correctly,
have a second person hold the strap on the opposite
side of the Spa Cover snug.) The Spa Cover must
be snug. Do not place the Buckle over the
grooves between the premium cedar panels. See
the inset drawing. Remove the latch from the Buckle.
Attach the Buckle to the panel with two #4 x 3/4”
Screws (27).

Attach the other three Buckles (26) to the panels in
the same way.

Remove the Spa Cover (11) from the spa.

5

Fill to here

Garden

Hose

Filter

Housing

6

11

26

Strap

Strap

Latch

26

27

3

22

5

38

3