7
2. Remove the screws and the wood brace from the
Uprights (109). Discard the screws and the brace.
Identify the left handrail, which has a hole in the indi-
cated location, and the right handrail. Hold the right
handrail near the right Upright (109), and insert the Wire
Harness (83) into the large hole in the right handrail and
out of the upper end as shown.
Next, hold the right handrail against the right Upright
(109). Tighten a 4” Bolt (112) three to four turns into the
right Upright and the lower end of the right handrail.
Tighten two 5/16” x 1” Bolts (122) into the upper end of
the right handrail and the right Upright.
Be careful not
to drop the Bolts into the handrail.
If necessary, raise
or lower the handrail to thread the 5/16” x 1” Bolts into
the right Upright.
Firmly tighten all three Bolts.
Attach the left handrail as described above. Note: There
is not a wire harness in the left Upright (109).
2
109
109
83
122
122
Brace
Left
Handrail
Right
Handrail
Hole
112
112
3. With the help of another person, hold the console as-
sembly near the right Upright (109) and the left Upright
(not shown).
Connect the Wire Harness (83) to the wire harness on
the console assembly.
Make sure to connect the con-
nectors properly (see the inset drawing); the con-
nectors should slide together easily and snap into
place.
If the connectors do not slide together easily and
snap into place, turn one connector and then try to con-
nect them.
IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON.
Insert the
excess wire harness back into the right handrail.
Set the console assembly on the right Upright (109) and
the Left Upright (not shown). Thread two 1/4” x 1” Bolts
(71) with 1/4” Star Washers (92) into each side of the
console assembly.
After you have started all four
Bolts, tighten them.
Console
Assembly
Right Handrail
83
92
71
83
3
109
Screw
Screw
Summary of Contents for PFTL91205.0
Page 25: ...25 NOTES...
