7
2. With the help of another person to orientate the
bottom of the right upright near the base as shown,
connect the cable coming from the right upright to the
one coming from the base.
than, place the right upright into the base like you did
with the left and attach it with 2 hex screw M8*45 (5)
and 2 washers (6) on the right of the upright and on
the front upright, use one hex screw M8*16 (64) and
one washer (6).
3. With the help of another person to ori-
entate the console near the top of the
upright, connect the upper cable coming
from the right upright to the one coming
down from the console.
Place the console on the 2 uprights and
than connect the console to each upright
with the help of 2 Hex Screw M8*16 (5)
and 2 Washers (6) for each upright.
4. Orient the foot cover as
showned on the drawing and
attach it to the frame with the
screw (101).
Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys
in a secure place. One of the hex keys is used to adjust the walking belt (see pages 17 and 18). To protect
the floor or carpet, place a mat under the treadmill.
2
4
3
PITL50714_manual_UK_M01300.indd 7
04/07/2014 10:54
