5
ASSEMBLY
Assembly requires two persons.
Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the
included hex keys and your own Phillips screwdriver , adjustable wrench , and
rubber mallet .
Use the drawings below to identify the small parts used for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following
the key number is the quantity needed for assembly.
Note: Some small parts may have been preassembled.
If a part is not in the hardware kit, check to see if it has been preassembled.
M4 x 16mm
Screw (52)–4
M10 Washer
(78)–2
M10 Split
Washer (59)–7
M10 Nylon Locknut
(33)–6
M10 x 30mm
Carriage Bolt (80)–2
M10 Bolt Set (74)–2
Handlebar Washer
(55)–2
Spring Bracket
Washer (35)–2
M8 Nylon Locknut
(38)–4
M8 x 45mm Button Bolt (50)–4
M10 x 27mm Patch
Screw (40)–2
M10 x 75mm Carriage Bolt (34)–4
Wave Washer
(43)–2
M8 x 25mm Patch
Screw (56)–2
M4 x 19mm
Screw (26)–2
M10 x 25mm Button
Screw (67)–3
M10 x 74mm Button Bolt (28)–2
23mm Wave
Washer (83)–2
Summary of Contents for ReflexStep
Page 24: ...24 NOTES...
Page 25: ...25 NOTES...
