DIAGRAM OF THE CONSOLE
Clip
Key
Speed Control
Displays
On/Reset Button
STEP BY STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in. (See page 7.) In
addition, make sure that batteries are installed in the
console. (See step 5 on page 6.)
Step onto the foot rails of the treadmill. Next, find the
clip attached to the key (see the drawing above). Slide
the clip onto your waistband. Test the clip by careful-
ly taking a few steps backward until the key is
pulled from the console. If the key is not pulled
from the console, adjust the position of the clip as
necessary.
Follow the steps below to operate the console.
Insert the key fully into the power switch.
Inserting the key will
not turn on the dis-
plays. The displays
will turn on when the
on/reset button is
pressed or when the
walking belt is start-
ed. Note: If you just installed batteries, the dis-
plays will already be on.
Reset the speed control and start the walking
belt.
Slide the speed control
until it stops at the
RESET position. Note:
Each time the walking
belt is stopped, the
speed control must
be moved to the
RESET position before the walking belt can be
restarted.
Next, slowly slide the speed control until the walk-
ing belt begins to move at slow speed. Carefully
step onto the walking belt and begin exercising.
Change the speed of the walking belt as desired
by sliding the speed control.
2
1
CAUTION:
Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing
above) whilst operating the treadmill. When
the key is removed from the console, the
walking belt will stop.
• Adjust the speed in small increments.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable
water bottle.
8
Note: If there is a thin sheet of clear
plastic on the console, remove it.
