10
10
10. Apply grease to two Wave Washers (78). Slide
a Wave Washer onto each end of the Handlebar
Axle (33).
Next, slide the Left and Right Handlebars (7, 9)
onto the Handlebar Axle (33).
Make sure that
each Handlebar is on the correct side of the
exercise bike.
Tighten an M8 x 16mm Screw (84), an Axle
Cover (49), and an M8 Washer (85) into each
end of the Handlebar Axle (33)
at the same
time.
49
49
78
33
85
85
84
84
9
7
Grease
12.
Make sure that all parts are properly tightened before you use the exercise bike.
Note: Extra parts may
be included. Place a mat beneath the exercise bike to protect the floor.
11
23
26
68
11. Remove the 1/2" Pedal Nut (68) from the shaft of
one of the Pedals (23).
See the lower drawing.
Make sure that there is
a Custom Washer (86), a Pedal Spring (42), a
Red Washer (71), a Pedal Bushing (43), a Black
Pedal Washer (79), and a Pedal Spacer (44) on
the shaft of the Pedal. In addition, make sure
that the Pedal Bushing is oriented as shown.
Firmly tighten the shaft of the Pedal (23)
clock-
wise
into the right Crank Arm (26). Then, tighten
the 1/2" Pedal Nut (68) onto the shaft.
Attach the other Pedal (not shown) in the
same way. Firmly tighten the Pedal coun-
terclockwise into the left Crank Arm (not
shown).
23
68
42
71
43
79
44
86
78
Summary of Contents for XP Whirlwind 320
Page 21: ...21 NOTES...
