V.
Removing the OEM Seat
A. Begin by lifting the lower seat cushion out from the rubber grommets
in the floor. Once the seat is free remove from the vehicle (See Fig. 3).
B. Remove the seat belts by removing the OEM nuts from their mounting
studs. Do not remove the shoulder straps anchored at each side of the
vehicle.
C. Remove the OEM seat back cushion by removing two 18mm nuts from
the lower mounting brackets near the seat belt mounting studs. Using a
screwdriver and depressing from above, release the OEM spring locking
tabs located on the top outer corners of the seat. (See Fig. 4)
D. With the seat removed, the OEM child restraint loops are exposed.
Remove the child restraint loops or bend them downward toward the
floor.
Note:
This is necessary for the Pro-gard Seat to fit properly in position.
VI.
Installing the ABS Floor Pan
A. Place the ABS Floor Pan in the vehicle, making sure that
there are no objects underneath of it. Insure that the Floor
Pan is all the way back and down against the rear seat area.
Note:
The floor pan does not cover the OEM seat grommets.
Note:
Floor pan may require securing to vehicle near “B” pillar
with screws
B. Reinstall the OEM Rear Door Scuff Plates on the Driver
and Passenger-side. (See Fig. 5)
Note:
The Door Scuff Trim Plates go on top of the ABS Floor Pan.
Note:
Minor Trimming to the lower portion of the Door Scuff trim may be required.
Note:
For a more secure fit, a screw where the door scuff trim and the “B” pillar
trim overlap may be required.
VII. Installing the ABS Transport Seat
A. Mount the Seat Locating Tabs (3S5601) to the bottom of the ABS
Seat using the supplied bolts (3X03) and the lock nuts (3X03).
(See Fig. 6)
B. Attach the (3P214) Divider Mounting Brackets using the supplied bolts (3X36) and whiz nuts
(3X16Z), before installing the seat in to the vehicle. (See Fig. 6)
Note:
The flat side of the bracket should face the driver’s side, the divider will mount flat against it.
C. Place the seat in the vehicle. Make sure the locating tabs slide into the OEM seat grommets in the
floor of vehicle. The seat will lap over the back edge of the floor pan.
D. The seat has a seat belt relief notches at each side. Position the seat belt straps in each relief, insuring
the seat belt has free travel through out it’s cycle.
Fig. 3
DRIVER SIDE SHOWN
REAR SEAT
LOWER CUSHION
pro-gard.com
800.480.6680
3
Fig. 4
OEM REAR SEAT
LOCKING TAB
PASSENGER SIDE SHOWN
REAR SCUFF PLATE
Fig. 5
ABS FLOOR PAN
UP
