Servicing
1. When the bin is full with paper cuts, draw it towards yourself and empty it. Do not use shredder
with an overfilled bin.
2. It is necessary to provide maintenance service of the device in a service centre every three
months (cleaning, lubricating of cutter blades) in order to comply with specified technical figures. In
case of intensive usage such maintenance procedures should be done once a month.
Operating device
1. Connect power cord to the mains.
2. Turn power switch to switch on the device (Fig.1-1), power indicator should lit (Fig.1-2)
3. Insert from 1 to 8 sheets (80g/m
2
) into feed opening. Shredder automatically starts when paper
is placed in the entry and stops when shredding is finished.
4. When the maximum quantity of sheets is exceeded, or paper is clutched in the opening, the
motor will stop automatically, autoreverse function will be activated and the sheets will be fed back.
“REV” indicator will light on control panel. Remove paper from feed opening and continue
shredding.
5. In case of clutching of paper press and hold “REV” button. The motor starts in reverse direction
and the paper will be fed back. Remove paper from feed opening and continue shredding.
6. To shred a CD put it in a special input tray.
It is forbidden to place more than 1 CD into input tray as well as place disks into feed opening.
7. Press FWD button if the engine did not start automatically.
8. When the work is finished turn power switch to "OFF" position
4
