6
7.3. Batch operation mode
(Counting mode for a specified number of banknotes)
-Press “
BTH
” button on control panel as many times as necessary until the display reads
the desired batch size
-Use additional button “+1” to set an exact number
-Repeat from the beginning of Table 7.2.
-Remove banknotes from the stacker
-Add banknotes if necessary
-Press “
BTH
” button several times to exit batch mode
-If an error occurs during counting, see Table 8
-Repeat from the beginning of Table 7.3.
7.4. Summation mode
-Press “
ADD
” button and the indicator will light up
-Repeat operations up to Table 7.2.
-When there are no more banknotes in the hopper, remove banknotes from the stacker
-Put a new stack of banknotes into the hopper
-Repeat from the beginning, when necessary
-The display will show the total result of counted banknotes
-When counting has finished, reset the displayed results by pressing “
START
” button
-Press “
ADD
” button to exit summation mode
-If an error occurs during counting, see Table 8
-Repeat sum up operation up to Table 7.4., when necessary
Figure 3
Figure 4
