© Pro-Ject Audio Systems · Pro-Ject 2
X
perience Primary · Revision 2018.03.08
6
Anti-skating force adjustment
The anti-skating force must be adjusted corresponding to the downforce as
follows:
Downforce
Groove in the stub (15)
10 - 14mN
1
st
from bearing rings
15 - 19mN
2
nd
" " "
20mN and bigger
3
rd
" " "
Hang the loop of the thread of the anti-skating weight into the groove of the anti-skating stub (12)
corresponding to the downforce applied to your cartridge and hang the thread in the groove of the
wire support (14).
Connection to the amplifier
The record player has gold plated female RCA phono sockets (11) so you can substitute the interconnect
cables supplied with higher quality cables such as the
Pro-Ject Connect IT
interconnect cables for
connection to the amplifier if you wish. Use the Phono input (sometimes labelled gram, disc or RIAA)
on your amplifier. Make sure that the phono input offers correct matching and amplification for the
type of cartridge used. Line inputs (like CD, Tuner, Tape or Video) are not suitable.
Take care about connecting the left and right channel correctly. The right channel is usually marked
red, the left channel black or white. Check the manual of your amplifier for relevant information. An
earthing wire may be connected to the screw terminal between the sockets if you encounter humming
problems.
If your amplifier does not have an input suitable for phono cartridges, a separate phono amplifier
stage for MM or MC cartridges is required. It has to be connected between record player and a free
line level input of the amplifier.
For detailed product information regarding Pro-Ject Audio Systems interconnect cables and phono
amplifiers please visit our website:
www.project-audio.com
Mains power connection
A universal power supply with 3 exchangeable sockets adapters suitable for all countries is supplied.
Select the correct adapter for your country and insert the adapter to the exchangeable part of the
power supply.
Connect the low voltage plug from the power supply to the socket (9) on the rear side of the record
player before
connecting the power supply to the mains.
Switching on and off
Pressing the power switch (16) alternately starts and stops the motor.
Changing replay speed
Use the accessory tool provided (3a), hook the belt (3) over the larger diameter part of the motor pulley
(2). To revert to 33 r.p.m. repeat the proceedings using the smaller step on the pulley.
