© Pro-Ject Audio Systems · CD Box S3 · Revision 2021.10.05
2
Dear music lover,
thank you for purchasing a CD Box S3 from Pro-Ject Audio Systems. In order to achieve maximum performance
and reliability you should study these instructions for use carefully.
Warning of a hazard for the user, the unit or possible misuse.
Important notice.
Caution! Laser diode, discs to avoid, safety instructions
This product contains a laser diode of higher class than 1. To ensure continued safety, do not remove any
covers or attempt to gain access to the inside of the product. Refer all servicing to qualified personnel.
If a disc is cracked, chipped, warped, or otherwise damaged, don't risk to play it. You could end up
damaging the unit. This player is designed for use with fully circular, full size CDs only. Use of shaped discs
is not recommended. The manufacturer and the distributor disclaims all liability arising in connection with
the use of damaged or shaped discs. AC outlet voltages vary from country to country. Before connecting
to the mains, make sure that the voltage in your area meets the voltage requirements printed on the
power supply. The power supply is used to disconnect the unit from the mains. Make sure that the power
supply is easily accessible at all times.
Never handle the device, the power supply while your hands are
wet or damp.
Avoid letting liquids enter the device or the power supply. Never place any item containing
liquid, such as a flower vase on or near the device. Never spill any liquid on the device or the power
supply. Never place any naked flame sources, such as lighted candles on or near the device. The product
shall not be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar
conditions.
Shape and condition of data carriers
If a CD is broken, chipped or otherwise damaged, it should not be played as it may damage the unit.
The device is only designed to play round CDs with 12cm Ø. Playing self-burned CDs that do not
comply with the Red Book standard may cause the unit to malfunction. The same applies to CDs with
stickers or chamfered outer edges.
Connectors
Make all connections whilst the CD player is disconnected from the power supply. Take care to
connect the left and right channels correctly. The right channel is usually marked red, the left channel
black or white. Never use any other power supply than the one supplied with the unit.
Connection to the amplifier or DAC
Connect the Analog Output socket to a line input (such as AUX) on your amplifier.
Connect the Cox-axial digital Output socket to an optical digital input on the D/A converter or amplifier
equipped with digital input.
