2
SAFETY INSTRUCTIONS
INSPECTIONS
This hydraulic trolley jack is designed to be used with a 60mm diameter head cap, and
a handle length of 700mm length.
1. BEFORE EACH USE
Visual inspection should be made before each use of the trolley jack for abnormal
conditions such as cracked welds, leaks and damaged, loose, or missing parts.
2. AFTER EACH USE
Trolley jack should be inspected immediately if the lift is believed to have been
subjected to an abnormal load or shock. It is recommended that inspection be made
by manufacturer’s or supplier’s authorised repair facility.
3. ANNUAL INSPECTION
Annual inspection of the trolley jack is recommended and is recommended to be
made by the manufacturer’s or supplier’s authorised repair facility to ensure that
your trolley jack is in optimum condition.
RECOMMENDATION FOR SAFE USAGE OF THE JACK
1. The hydraulic trolley jack should be used on a hard level surface and be free to roll
during lifting and lowering.
2. The unlifted wheels of the vehicle should be chocked.
3. The load should be centrally located on the head cap.
4. No person should remain in a vehicle that is being lifted.
5. The hydraulic trolley jack should be used for lifting and lowering only; the raised
vehicle should be supported on vehicle support stands.
6. No person should get bodily under a vehicle that is supported by a hydraulic trolley
jack.
7. The vehicle manufacturer owner’s manual should be consulted prior to the lifting of
the vehicle.
8. Make sure that lift point is stable and properly centred on jack saddle.
9. Transmission should be in gear (or park for automatic transmissions) and the
emergency brake should be engaged.
10. Familiarise yourself thoroughly with this owner manual before operation to prevent
damage to jack and property, or personal injury.
CAUTION BEFORE USE
Due to shipment and/or handling air can be trapped in the hydraulic system, which can
interfere with the jacks lifting. To release air from the hydraulic system:
• Open release valve by turning the jack handle counterclockwise.
• Remove the oil filler plug from the cylinder.
• Rapidly pump jack handle through several full strokes.
• Replace the oil filler plug into the cylinder.
!
!
WARNING:
• THE JACK MUST BE USED ONLY ON HARD LEVEL SURFACES AND BE FREE
TO ROLL DURING LIFTING AND LOWERING
• DO NOT GET UNDER A VEHICLE THAT IS SUPPORT BY A TROLLEY JACK
- USE SUPPORT STANDS
