17
battery terminals through breakers or inline fuses. The circuit breaker is located at the helm
next to the manual switch. Depressing the bilge pump switch to the up or forward position
activates the bilge pump. If for some reason the indicator light on your bilge pump switch comes
on, check your bilge for water. It is not uncommon for rain water or water from washing your
boat to accumulate in the bilge. Standing water will activate the automatic float that is
connected to the bilge pump. If you notice your pump running frequently during your day on the
water, you should check the thru hull fittings, hose connections, etc. for any possible leaks.
Keep the bilge area clean and free from debris that could clog ports or inhibit float movement.
Also, keep the battery (starboard) that provides power to the bilge pump charged. If the battery
is not charged and flooding occurs, the boat could swamp causing damage and possible loss of
life or property.
4 Baitwell
Pump - The baitwell pump is located in the bilge area and is plumbed to a seacock (ball
valve). This pump is also used for the raw water washdown. See the Sea Water section of this
manual for instructions on using the raw water washdown fitting.
For the pump to operate properly you need to make sure the seacock is in the open position.
The seacock is wide open when the yellow seacock lever is vertical. When the yellow seacock
lever is horizontal, the seacock is closed. The underside of the seacock thru-hull is equipped
with a scoop to allow the water to be picked up even when the boat is on plane. When the boat
is not in the water or the baitwell pump is not going to be used for an extended period of time,
the seacock valve should be in the closed position.
To activate the pump, depress the switch to the up or forward position. To turn the pump off
after the baitwell tub is full, depress switch to the down or aft position.
5 Fresh
Water – A fresh water system is not available on the 2
1
Sport, however, you may select to
use this switch as an accessory switch for additional dealer installed accessories. Please check
the amp rating of any new component and/or additional accessory before installation.
6 Cockpit Lights (Optional) – Your vessel may be equipped with cockpit/ courtesy lights. The
lights have LED (light emitting diode) bulbs with a lifespan of approximately 10,000 hours. To
activate the lights, depress the switch to the up or forward position. The lights give off a soft
warm light which should not affect your night vision, but will still provide you with enough light to
safely move around your cockpit in low visibility conditions.
7 Baitwell
Light - To activate the baitwell light, depress the switch to the up or forward position.
This will activate the LED (light emitting diode) light inside your baitwell tub. It is a soft white
light that will keep your bait moving and lively. It will also help you locate your bait on those
early morning or late night fishing trips. To turn the light off, simply depress the switch to the
down or aft position.
8 Accessory – This 5 amp accessory switch can be used for additional dealer installed
accessories. Please check the amp rating of any new component and/or additional accessory
before installation.
Lighting Systems
Cabin Light – Head
The cabin light is installed in the ceiling of the head area. The dealer-installed battery provides power to
this light. Press the small button on the base of the light assembly to turn on the light. Press the button
again to turn the light off.
