19
•
To operate the dome shaped courtesy light - Press the switch labeled courtesy once to
turn on the white courtesy light. When you press the same switch a 2
nd
time, the white
courtesy light will be turned off and the red courtesy light (for night vision) will turn on.
Press the same switch a 3
rd
time to turn off the red courtesy light.
•
To operate the spreader lights - The spreader light switch operates in the same manor as
the courtesy light but only needs to be pressed in once to be turned on and once again to
be turned off.
Remote Spot Light (Optional)
The installation of the remote spot light requires the optional rigid T-top. The remote spot light is mounted
to the forward area of the T-top. To operate the remote spot light, locate the remote spot light panel that
is installed on the console.
The switch on the right side of the panel allows you to turn the light on and off. The red LED light located
in the center of the panel will be lit when the spot light is turned on. Once the spot light is turned on, the
all around toggle lever (on the left side of the panel) can be moved in an up, down, left or right position to
rotate the light assembly in the desired direction.
Instrumentation
Horn - Electric
To check and see if the horn is working properly, press the horn switch in the forward position and listen
to hear the horn. The horn is used to signal, warn or alert other boats or persons on shore. The horn
switch is located on the switch panel. The horn device is located on the starboard gunwale nea
r
the bow
pulpit. Depress the horn switch to the up or forward position to activate the horn, then release the horn
switch to deactivate the horn. Using different sequences of horn blasts indicates different and sometimes
dangerous situations to you or someone around you.
See the Safety Section in this manual for more information. Avoid any horn use without an appropriate
purpose. Additional information regarding audible warning signals should be covered in a safe boating
course.
Compass
The Compass on the 21 Sport is located on the dash on top of the
console. To ensure that the compass light is working properly,
press the Nav/Anc switch in the forward position to turn on the red
LED light inside the compass. When finished, turn the Nav/Anc
switch back to the middle position.
Please refer to the owner’s manual provided by the manufacturer
of the compass for operational procedures and for information
related to the care and maintenance of their product. When in
doubt, always defer to the compass manufacturer’s instructions
and/or recommendations.
Remote
Spot Light
Remote Spot
Light Control
Panel
