When you have to store the panels of your windscreen and curtain package, always “roll up” the material to
prevent
creases
. Do not fold the Isinglass as this will permanently damage the Isinglass material. Do not roll up
the panels when wet, as the material will turn white or fog up. Dry the panels off first using a very very soft cloth
before rolling them up. A few hours in the sun will get rid of the whiteness or fogginess in most cases.
Vinyl
Exterior Vinyl – Upholstered Seats
Vinyl requires periodic cleaning to maintain its neat appearance and to prevent the build-up of dirt and
contaminants that may permanently stain and reduce the life of the vinyl if they are not removed. The frequency
of cleaning depends on the amount of use and on environmental conditions to which the vinyl is subjected. The
procedures used for cleaning are dependent upon the end use circumstances.
For normal cleaning, most stains can be cleaned using warm soapy water and a clear water rinse. Moderate
scrubbing with a medium bristle brush will help to loosen soiling material from the depressions of embossed
surfaces. For stubborn stains, use either Fantastic or Mr. Clean, which are commercially available mild
detergents, in accordance with manufacturers instructions.
For additional information regarding the care and maintenance of this product, please refer to the Morbern
brochure provided in your owner’s package for recommended methods to clean specific types of stains.
Power-Pole™
•
Check all hydraulic lines at frequent intervals for proper tightness to be sure there are no leaks.
•
Make sure all power connections are secure and free of corrosion.
•
Check all nuts, bolts, and screws at frequent intervals for proper tightness to be sure Power-Pole™ is in
safe working condition.
•
Check all hydraulic lines at frequent intervals for possible chaffing or damage from kinking or abrasion.
•
Keep the hydraulic reservoir filled within the indicator marks at all times
•
Thoroughly rinse all moving parts after each use.
•
Lubricate the hinge bushings periodically with a spray Lithium Grease to prevent the unit from squeaking.
Caution: Hydraulic lines always have pressure. Disconnecting the lines will cause sudden high-
pressure leakage and Power-Pole
TM
failure, which may cause bodily harm.
Winterizing
and St
or
age
Your new Pro-Line was winterized before it left the factory. If you launch the boat prior to storing it for the winter,
please complete and/or comply with the following check list in order to ensure an easy “fitting out” in the spring:
Pre-Storage Check List:
•
Remove drain plugs, keeping the bow high to drain any water accumulation.
•
Run a pint of RV antifreeze through the bilge pump.
•
Drain all water systems, including the head, and pump an approved antifreeze through all pumps,
valves, drains and lines.
•
Fill fuel tank (3/4 – 7/8 full) and add a stabilizer/conditioner such as “STA-BIL” to the gasoline.
•
Prepare engine in accordance with the engine manufacturer’s recommendations found in your
engine manual.
•
Treat metal parts with a rust inhibiter.
45
