44
the panels when wet, as the material will turn white or fog up. Dry the panels off first using a very very soft cloth
before rolling them up. A few hours in the sun will get rid of the whiteness or fogginess in most cases.
Vinyl
Interior Vinyl - Cabin Headliner and Cabin Bolsters
Clean periodically to maintain the appearance of the vinyl and to prevent the build-up of dirt and contaminants.
Any stain, spill or soiling should be cleaned promptly to prevent the possibility of permanent staining. When
cleaning, always scrub gently using a soft cloth or nylon bristle brush.
Caution: Powered abrasives, abrasive cleaners and steel wool will damage vinyl, as do strong
solvents, lacquer solutions and inks. Lotions, suntan oil, waxes and polishes, etc.,
contain oils
and dyes that can cause stiffening and staining of the vinyl. Never use steam, heat guns or hair
dryers.
For additional information regarding the care and maintenance of this product, please refer to the Morbern
brochure provided in your owner’s package for recommended methods to clean specific types of stains.
Exterior Vinyl – Upholstered Seats and Cockpit Bolsters
Vinyl requires periodic cleaning to maintain its neat appearance and to prevent the build-up of dirt and
contaminants that may permanently stain and reduce the life of the vinyl if they are not removed. The frequency
of cleaning depends on the amount of use and on environmental conditions to which the vinyl is subjected. The
procedures used for cleaning are dependent upon the end use circumstances.
For normal cleaning, most stains can be cleaned using warm soapy water and a clear water rinse. Moderate
scrubbing with a medium bristle brush will help to loosen soiling material from the depressions of embossed
surfaces. For stubborn stains, use either Fantastic or Mr. Clean, which are commercially available mild
detergents, in accordance with manufacturers instructions.
For additional information regarding the care and maintenance of this product, please refer to the Morbern
brochure provided in your owner’s package for recommended methods to clean specific types of stains.
Single Burner Butane Stove
Body/base of the stove: Allow the stove to cool completely and remove the butane canister before attempting to
clean the unit. Wash the outside of the unit, the drip pan and the canister cover with warm water. Then dry all
parts with a cloth.
Burner head and surroundings: Keep the flame holes on the burner head clean. Clogged flame holes will affect
the combustion process. Use a metal brush to clean the flame hole. Do no immerse in water.
Ignition plug: The ignition plug will not function if it is wet. If the plug becomes wet, dry it with a soft cloth or allow
it to air dry.
Winterizing and Storage
Your new Pro-Line was winterized before it left the factory. If you launch the boat prior to storing it for the winter,
please complete and/or comply with the following check list in order to ensure an easy “fitting out” in the spring:
Pre-Storage Check List:
•
Remove drain plugs, keeping the bow high to drain any water accumulation.
•
Run a pint of RV antifreeze through the bilge pump.
•
Drain all water systems, including the head, and pump an approved antifreeze through all pumps,
valves, drains and lines.
•
Fill fuel tank (3/4 – 7/8 full) and add a stabilizer/conditioner such as “STA-BIL” to the gasoline.
Summary of Contents for 2009 26 Express
Page 2: ...ii...
