32
Please see the Service and Care section of this manual for information on how to clean and care for your cabin
cushions, pillows vinyl upholstery.
Stove (Optional)
An optional single burner butane stove can be installed in the cabin. See the
Service and Care section of this manual for cleaning recommendations.
Please refer to the owner’s manual provided by the manufacturer of the
butane stove for operational procedures and for information related to the
care and maintenance of their product. When in doubt, always defer to the
stove manufacturer’s instructions and/or recommendations.
Be sure to familiarize yourself with all of the safety instructions provided by
the stove manufacturer.
How to install the butane canister: Open the canister cover. Make sure the ignition knob is in the off position and
the canister lever is in the release position. If the ignition knob is not completely in the off position, the canister
cannot be engaged into the lock position. Install the canister so that the canister hole is aligned with the canister
guide. Lock by pushing the canister lever down and then close the canister cover. Before turning the unit on,
check that the canister is positioned properly and that the canister lever is in the on position.
How to ignite: Turn the ignition knob 90 degrees counter clockwise completely until you hear a click sound. If the
burner does not light, repeat the ignition procedure.
How to control the flame: Turning the ignition knob slowly toward the off position from the on position can
regulate the size of the flame.
How to extinguish: Turn the ignition knob clockwise to the off position. The flame is automatically put out and
there is no gas supplied. The flame will be extinguished before the ignition knob is turned completely to the off
position. Make sure to check that the flame is off. Be sure to raise the canister lever up to the release position.
Open the canister cover and then take the canister out.
Burning off the remaining fuel: Some fuel may remain in the gas line. After the unit is in the release position, turn
the ignition knob to the on position to burn off any remaining fuel.
Vinyl Upholstery
Please see the Service and Care section of this manual for information on how to clean and care for your seat
cushions and cockpit bolsters.
Electronics (Optional)
Based upon the availability from our vendors, this equipment changes from time to time. Therefore, we request
that you refer to the owner’s manual provided by the manufacturer of your electronics equipment for operational
procedures and for information related to the warranty and the care and maintenance of their product. Refer to
your owner’s package for additional information.
Bonding System
All metal components that have water either going through them or touching them are bonded to the zinc anodes
on the transom of the boat. The zinc anodes should be checked periodically and changed when needed.
Summary of Contents for 2010 23 XP
Page 2: ...ii...
