Pro-Line Boats 2010 26 Express, Owner'S Manual

40

 
Antifouling bottom paint is designed to dissolve slowly to prevent marine growth.  Therefore, the hull bottom 
should be repainted at the beginning of each boating season.  Factors to take into consideration when selecting a 
protective bottom paint are water temperature, pollution, salinity, current and organic material in the water. 
 

Important:  Consult your Pro-Line dealer’s Service Department or another qualified service 
professional for recommended bottom paints and local laws that may govern your area.  Many 
states regulate the chemical content of bottom paints to meet environmental standards and 
regulations. 

 
Blisters are unforeseen and unexplained phenomena that are relatively undefined.  There is no 100% method of 
prevention, although barrier coating and bottom painting are the best known deterrents. 
 
We recommend that a professional apply the epoxy barrier coat and bottom paint.  The hull should be sanded 
prior to applying the barrier coat and bottom paint.  This is done so that the epoxy coat will properly adhere to the 
hull, and when done correctly, will not void the hull warranty.  Pro-Line Boats does not recommend using an 
etching primer in lieu of sanding the bottom. 
  
Bottom painting is an annual operation but may require more frequent applications if the bottom becomes 
scratched, damaged, etc.  We recommend strict adherence to the manufacturer's recommendations when barrier 
coating and bottom painting your vessel.  There is a small window of time in which the coats must be applied in 
order to properly complete the application process; therefore, we recommend that a qualified professional do this 
process. 
 
While barrier coating and bottom painting are the best preventative to blisters caused by the environment, this is 
in no way a guarantee that they will not occur. 
 

Graphics 

 
Your graphics may be cleaned with a mild dish cleaning soap and warm water or a good marine grade cleaner 
that is recommended for cleaning gelcoat.  Never use any harsh chemicals, abrasive cleaners or any hard 
objects, as they will damage the graphics.  Be sure to read the manufacturer’s directions carefully before using 
any product on your graphics or gelcoat. 
 

Gunwale Trim / Rubrail 

 
The gunwale trim/rubrail that is installed at the juncture of the deck and hull is made of flexible, semi-rigid vinyl 
and a stainless steel insert.  The rigid vinyl should be cleaned with the same products used to clean the gelcoat.  
Please follow the recommendations for stainless steel for cleaning the stainless steel insert. 
 

Washdown and Fresh Water Pumps 

 
The round filter attached to the side of the pumps should be removed and cleaned often with clear water. 
 

Fuel Water Separators 

 
If fuel water separators are installed on your boat, the “spin on” filter cartridges should be renewed every season 
at a minimum.  Fuel tanks that are not kept full accumulate water faster due to condensation.  Therefore, filter 
cartridges may need to be replaced more often depending upon usage and conditions or if motors begin to run 
rough.  When replacing the filters for the fuel water separators, coat the rubber seal with a film of grease or oil to 
help prevent sticking. 
 

Compass 

 
During periods of long storage, it is recommended that you remove the compass from the boat and store it in a 
location providing normal room temperature.  At low temperatures, an air bubble may form on the top of the