Pro-Line Boats 2012 21 CC, Owner'S Manual

19

Hand Rails 

Bow Handrail - The bow handrail is constructed of stainless steel.  The railing, which is through bolted to the gunwale, is 
provided for safety.  Never use the bow rail to tie off to anything heavier than a bumper/fender.  Do not use the bow rail for 
anchoring, or to tie off to the dock or another boat.  Do not use the bow rail to tow another boat or skier.  Never stand on 
the bow rail or use it as leverage when pulling up an anchor, a fish or any other objects.  Do not use the bow rail to tie off 
and/or secure a large catch, etc. 
 
Windshield Grab Rail (Optional)

– A stainless steel grab rail is available for installation on some SE Series models.

Gunwale Trim / Rubrail

Depending on which SE Series model you have selected, your boat will be equipped with either heavy duty gray or rigid 
vinyl rubrail which is installed at the juncture of the deck and hull.  This durable trim provides a nice clean look and serves 
as somewhat of a cushion when you are docking, coming along side another vessel, etc.  
 
See the Service and Care section of this manual for cleaning recommendations. 
 

Thru Hull Fittings 

Durable plastic thru hull fittings are installed to provide overboard drainage for the following areas: 
 



 Bilge 



 Baitwell 



 Cockpit 



Fish box  (Does not apply to all SE Series models) 



Casting deck storage 

Drain Plug 

Before launching the boat, always make sure that the drain plug has been installed in the fitting on the transom at the 
keel.  If your boat is being transported, remove the drain plug once the boat is secured on the trailer so that any excess 
water can be drained via the fitting.  Never remove the drain plug when the boat is sitting static in the water. 
 
If you live in an area where it snows and you are storing your boat on a lift during the winter, make sure that you remove 
the drain plug.  When the snow melts, if the float switch for the bilge pump happens to fail, it could flood the bilge and 
damage electrical components in the bilge. 
 

Cockpit / Deck Drains 

Cockpit drains are installed in the aft area of the cockpit that allow excess water in the 
cockpit to drain overboard via thru hulls on each side of the boat.  To ensure that there is 
no blockage in any of the hoses connected to the drains, it is recommended that you 
occasionally run water through each of the cockpit drains and visually inspect the thru hulls 
to verify that water flows freely and that there is no blockage.  To trouble shoot, check the 
hoses for leaks and make certain that all hose connections are secure. 

Half Dive Platform with Ladder (Optional)

The ladder on the dive platform allows you easy boarding and lets you easily stow away the step. 
 

Note:  Not available on all SE Series models. 

Bimini Top (Optional) 

The frame is made of anodized aluminum and the Bimini canvas top is made of high quality Sunbrella canvas.  Please 
see the Service and Care section of this manual for cleaning and care recommendations. 

Canvas T-Top (Optional)

The anodized aluminum frame comes with a canvas top.  See the Service and Care section of this manual for cleaning 
recommendations for the anodized aluminum frame and the canvas top. 
 

Note:  Not available on all SE Series models. 

Note:  Pro-Line installs mounting pads to the frame for additional support when outriggers are factory 
installed.  Before adding after market outriggers, we recommend that you consult your Pro-Line dealer’s 
Service Department or another qualified service professional to add mounting pads to the T-Top frame