22
The shore power outlet is located on the outside of the starboard wing and aft of the starboard portlight.
To connect your shore power system:
•
Turn the shore power outlet fitting and lift it up.
•
Plug the shore power cord into the outlet on the boat.
•
Connect the shore power cord to the receptacle at your marina or dock.
•
Only then should you switch the AC main breaker to “On”.
•
If the polarity light (red) is on, unplug shore power (first at the shore outlet, then at the
shore power outlet on the boat) and do not use it, until a qualified technician corrects this
potentially dangerous situation.
Please refer to the owner’s manual provided by the manufacturer of the shore power unit for operational
procedures and for information related to the care and maintenance of their product. When in doubt,
always defer to the shore power manufacturer’s instructions and/or recommendations.
Switch and Breaker Panel
The switch and breaker panel is located on the console and is equipped with 16 switches. The numbers
beneath the photo of the switch and breaker panel shown below correspond with the description provided
for each switch.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
16
1 Horn - The horn is used to signal, warn, or alert other boats, swimmers or people on shore.
Depress the horn switch to the up or forward position to activate the horn. Release the horn
switch to deactivate the horn. Using different sequences of horn blasts indicates different and
sometimes dangerous situations to you or someone around you.
Avoid any horn use without an appropriate purpose. See the Safety Section in this manual
and/or take a safe boating course for more information on the proper use of the horn.
2 Navigation & Anchor Lights - Locate the Nav. light switch on the instrument panel. This is a 3-
way switch (forward, middle, back/aft) that functions as follows when you press the switch:
•
Forward position - Turns on the bow lights and the anchor light. This position
will also activate the red light in your compass.
o
If you have Faria gauges on the dash panel, this function will
illuminate the gauge lights.
o
If the gauges were provided by the engine manufacturer (i.e.,
Mercury, Honda, etc.), this switch will not illuminate the gauge
lights. Instead, your gauge lights will be illuminated when the
ignition switch is turned on.
