26
Cockpit Lights
The cockpit lights are small circular lights located around the cockpit aft of the helm
seat. Locate the 2-way cockpit light switch on the switch panel and press the switch
in the forward position to turn on the 3 cockpit lights. Press the cockpit Light switch
in the back or aft position to turn the lights off.
With the installation of the standard hard top, an additional 12
cockpit lights are installed on the underside of the fiberglass
hard top along with a switch panel for the lighting system.
This switch panel which is easily accessible from the helm
station provides switches for the following:
•
Spreader lights
•
Aft overhead cockpit lights
•
Forward overhead cockpit lights
•
Docking lights (Optional)
The switches for the overhead courtesy lights are 3 position switches. When pressed in the forward or up
position, the white lights are illuminated. When pressed in the aft or down position, the red lights are
illuminated. When pressed in the middle/center position, the lights are turned off.
Note: With the installation of the optional tower:
o
Spreader lights and docking lights are controlled by the 2 accessory
switches on the console switch panel.
o
Overhead cockpit lights not available.
Navigation and Anchor Lights
The navigation and anchor/all around lights are required to be used for operation at night or under low
visibility conditions to indicate your position to other boaters. Visually verify the operation of your
navigation/anchor lights and verify that the lights are free from obstructions. You should check your
navigation lights monthly during optimum visibility conditions.
Navigation Lights - The navigation lights
consist of a pair of stainless steel lights that are
mounted to the fiberglass hard top. The red
light is installed on the port side and the green
light is installed on the starboard side.
Anchor Light/All Around Light - This light is
mounted on the center of the fiberglass top and
must be adjusted to the “up” position when the
boat is underway.
•
When you are underway in low visibility conditions, you should have the nav. light switch
in the up or forward position. This will activate the navigation lights, as well as your
anchor/all around light.
•
When you are anchored or in low visibility conditions, you should turn on the anchor/all
around light. Press the nav. light switch to the down or aft position to turn on the
anchor/all around light.
Spreader
Lights
Aft Overhead
Lights
Forward
Overhead
Lights
Docking
Lights
