Pro-Line Boats VS-I30, User Manual

INSTALLATION AND OPERATING INSTRUCTIONS  

23

Problem

Possible Cause

Solution

Vacuum sealer bag loses 

vacuum after being sealed

1.  Bag not sealed properly.
2.  Moisture or juices from 

foods.

3.  Bag has a hole.

1.  Wrinkles, crumbs, grease or liquids may cause leaks along the 

seal. Reopen bag, wipe the top inside of the bag and smooth it out 
along the sealing strip before resealing.

2.  Check if there is moisture or juices from the food present within 

the bag, if yes, you may need to cut open the bag and reseal it, 
or use an entirely new bag. Foods with excess liquids should be 
frozen before vacuum sealing.

3.  Items with sharp edges may have punctured the bag, releasing the 

vacuum. Cushion sharp edges in the contents of the bag with paper 
towels.

Vacuum sealer not sealing 

bag properly

1.  Sealing strip is too hot.
2.  Seal Only function still active 

or needs to reset.

1.  The sealing strip may have overheated and melted the bag. Lift the 

lid and allow sealing strip to cool for a few minutes.

2.  Before re-pressing the “seal only” button, allow the unit to resume 

for 15 seconds.

The canisters and bowl will 

not vacuum

1.  Lower & Upper gaskets are 

not forming an air tight seal.

2.  Canister lid dial not in SEAL 

position.

3.  Accessory hose not correctly 

attached to Vacuum Seal 

Hose Port or canister lid.

1.  Ensure Gaskets are correctly sealed and are not compressed. See 

page 15 for further information on Gaskets.

2.  Gently turn the canister lid dial arrow to SEAL position.
3.  Make sure accessory hose is firmly pushed in all the way into 

Vacuum Seal Hose Port on appliance and canister lid.