10.8V Li-ion Cordless Mini Drill Driver
7
For technical questions call: 1-800-665-8685
V 2.0
8380271
OPERATION
PARTS IDENTIFICATION
ACCESSORY
INSTALLING OR REMOVING BATTERY PACK
1. Always switch off the machine before insertion or removal of the battery pack.
2. To remove the battery pack, pull out the set plate on the machine and grasp
both sides of the battery pack while withdrawing it from the machine.
3. To insert the battery pack, align the tongue in the battery pack with the groove
in the housing and slip it into place. Snap the set plate back into place. Be sure
to close the set plate fully before using the machine.
4. Do not use force when inserting the battery pack. If the battery pack does not
slide in easily, it is not being inserted correctly.
CHARGING THE BATTERY PACK (SEE FIG.5)
1. Your new battery pack is not charged. You will need to charge it before use.
2. If you try to charge a battery pack from a just-operated machine, sometimes
the charging light will not come on. If this occurs, let the battery pack cool off
for a while. Then reinsert it and try to charge it once more.
3. When you charge a new battery pack or a battery pack which has not
been used for a long period, it may not accept a full charge. This is a normal
condition and does not indicate a problem. You can recharge the battery pack
fully after discharging it completely a couple of times.
4. If you wish to charge two battery packs, allow 15 minutes between charging
on the fast charger.
5. Plug the fast charger into you source. Insert battery pack so that the plus and
minus terminals on the battery pack are in the same slides as their respective
markings on the fast charger.
6. The charging light will come on and charging will begin. If the charging light go out soon, remove
the battery pack from the charger and let it cool off for more than one minute. Then reinsert it and try to charge
it once more.
7. If the charging light goes out within one minute even after repeating this procedure a couple of times, the
battery pack is dead. Replace it with a new one. When the charging light goes out after about one hour, you
may remove the fully charged battery pack.
8. After charging, unplug the charger from the power source.
Charger
Fig. 2
Fig. 5
Fig. 3
Fig. 4
