8348674
AIR NEEDLE SCALER
V1.0
10
For technical questions call 1-800-665-8685
1. All air tools have an internal coating of grease to prevent
corrosion during shipping and storage. Remove this grease by
adding a generous amount of air tool oil in the air inlet and
then run the tool under no load until the exhaust is clear.
2. Manually add a drop or two of air tool oil into the tool’s
male connector before each use and after every hour of
continuous use. The tool will not work properly without
lubrication and parts will wear prematurely.
3. Avoid adding too much air tool oil as this can cause
premature power loss and eventual tool failure. A qualified
technician will need to take the tool apart and clean out the
excess oil.
4. Apply a generous amount of air tool oil to the tool before
storing it for an extended period of time (overnight,
weekend, etc.). Run the tool for approximately 30 seconds
to ensure the oil is evenly distributed throughout the tool.
Store it in a clean and dry location.
STORAGE
When not in use for an extended period, apply a thin coat of
lubricant to the steel parts to avoid rust. Remove the lubricant
before using the tool again.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or
by-laws for electronic devices, batteries, oil or other toxic liquids.
IMPORTANT! DO NOT pollute the environment by allowing
uncontrolled discharge of waste oil.
