8348674
AIR NEEDLE SCALER
V1.0
8
For technical questions call 1-800-665-8685
1. Wrap the external threads of the male connector with
sealant tape.
1.1 Wrap tape in a clockwise direction so it will not unravel.
1.2 Do not tape all the threads. Leave several leading
threads unwrapped for easier alignment.
2. Screw the connector into the tool's air inlet and tighten
with a wrench until snug.
3. Run the compressor at a low volume and check the
connection for air leaks. Do not use the tool until all air
leaks are repaired or the faulty component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is
connected directly to the air tool. To overcome this, connect a
leader hose to the tool. A quick coupler may then be used to
connect the leader hose to the air line hose.
OPERATION
1. Grip the tool with both hands. Place one hand on the
needle housing (#27) and the other hand on the tool body.
2. Press the lever (#7) to operate. Make sure the needles (#24)
are not touching any surface when you turn on the tool.
3. Place the vibrating needles on the work surface. Move the
needle scaler around in the area from which you wish to
remove the material.
4. Keep only light pressure on the tool while in use. Do not
apply heavy pressure as it may damage the surface area.
5. Do not hold the needle scaler in any one area of the work
surface for more than a few seconds. Longer intervals could
damage the surface.
6. If the needle scaler will not remove the material from the
surface after a few short attempts, do not continue. Use
another method to remove the material.
