7" Metal Cutting Circular Saw
9
For technical questions call: 1-800-665-8685
8380263
V 1.0
Fig. 9
Fig. 10
Fig. 11
MAINTENANCE
CHIP COLLECTION AND REMOVAL OF THE CHAMBER
Removal:
1. Remove the Hex Key from the carrying case.
2. Open latch. (fig.6) (there is a white mark on the hex head bolt to be positioned as shown to open
collection unit.)
3. Tilt the saw so that the collection unit faces down. (fig.8)
4. Hold the collection unit and pull away from the saw.
5. Slide the collection unit off the hook and gently shake the metal chips out of the chamber into a proper disposal
bin. It should not be necessary to remove the back of the collection chamber to dispose of the chips
within the chamber.
Fig. 7
Fig. 8
RE-ATTACHING:
1. Place the collection unit back onto the body of the saw.
2. Check for alignment of the collection unit with the back hook and the saw body. (fig.9)
Note:
The back hook goes between the collection unit and the pin that is also fastened to the collection unit.
3. Rotate the hex head bolt to the closed position. (fig.10)
4. Remove hex key from the hex bolt and replace the key into the carrying case.
Summary of Contents for 8380263
Page 1: ...User Manual 8380263 V 1 0 7 Metal Cutting Circular Saw Please read this manual before use ...
Page 2: ......
Page 14: ......
