V1.0
6 in. Composite Orbital Air Palm Sander
8630790
tool again. The tool should be run for approximately 30 seconds to
ensure oil has been evenly distributed throughout the tool. The tool
should be stored in a clean and dry environment.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not
function properly or parts are missing. If unable to do so, have a
qualified technician service the tool.
PROBLEM(S)
POSSIBLE CAUSE(S)
SUGGESTED
SOLUTION(S)
Housing heats up
during use.
1. Incorrect lubrication
or not enough
lubrication.
1. Lubricate using air
tool oil and grease
according to directions.
2. Worn parts.
2. Have a qualified
service technician
inspect the internal
mechanism and replace
worn parts as needed.
Severe air leakage.
(Slight air leakage is
normal, especially in
older tools.)
1. Cross-threaded
housing components.
1. Check for incorrect
alignment and uneven
gaps. If cross-threaded,
disassemble and replace
the damaged parts
before use.
2. Loose housing.
2. Tighten the housing
assembly. If the
housing cannot be
tightened properly,
the internal parts may
be misaligned.
3. Damaged valve
or housing.
3. Replace damaged
components.
Visit www.princessauto.com for more information
15
