DANGER! When the tool is in operation, keep hands away
from the saw blade and the area it is being applied to.
Failure to follow this warning will result in amputation,
serious personal injury or death
WARNING! Some surfaces contain materials which can be
toxic. When working on materials that may contain lead,
asbestos, copper chromium arsenate or other toxic
materials, extra care should be taken to avoid inhalation and
minimize skin contact.
1.
Use the correct tool for the job. This tool was designed for a
specific function. Do not modify or alter this tool or use it for an
unintended purpose.
2. Do not use the tool if any parts are damage broken or misplaced.
Repair or replace the parts.
3. Only use a circular saw disc that is specifically designed for use
with the mitre saw. Ensure the circular saw disc is tightly installed.
4. Do not use a circular saw disc that is dull or damaged. When a
circular saw disc is dull, it requires more force to use the tool,
possibly causing the circular saw disc to break. This may cause an
injury and will damage the workpiece.
a. Dull or improperly set saw blade produces a narrow kerf that
can cause excessive friction on the saw blade, resulting in
binding or a kickback. Keep the saw blade’s edge sharp and
clean.
5. Only use a circular saw disc that exceeds the Speed Rating (see
Specifications).
6. Use the correct mounting hardware. The mounting hardware is
designed to hold the circular saw disc on the tool to allow optimum
performance and safety of operation. Mismatched mounting
hardware may result in a tool malfunction and cause an injury.
a. Always use a circular saw disc that is correctly sized and
shaped for the tool. Accessories that do not match the tool’s
mounting hardware will run erratically, causing loss of control.
7.
Check the circular saw disc for damage before each use. A
damaged circular saw disc can break during use and cause
serious injury.
8987646
2-SPEED SLIDING MITER SAW
V1.0
Assistance available at www.princessauto.com or 1-800-665-8685
Page 6
