15
E
N
G
L
IS
H
SAFETY PRECAUTIONS FOR COMPRESSORS
9. REPLACEMENT PARTS.
When servicing, use only identical replacement
parts and fasteners recommended by us.
10. USERS
must comply with the safety warnings and all other instructions
in this manual. Keep it available for use by everyone assigned to use this
equipment.
1. TANK SAFETY VALVE:
This valve prevents damage to the air receiver if
a malfunction in the compressor pump occurs. It is factory pre-set at a limit
specific to your particular model and adjustment. Do not tamper with it. This
will automatically void your warranty.
2. PRESSURE SWITCH:
The air pressure switch is factory pre-set for
optimum performance. Do not bypass or remove this switch. Serious
damage to equipment or personal injury could result from too high an air
pressure.
3. MOTOR AND COMPRESSOR PUMP:
Air compressors get hot during
operation. Do not touch the motor, discharge tubing, or compressor while it
is running. The compressor turns itself on automatically while the power is
connected.
4. AIR TANK:
Over-pressurizing the air receiver, piping or tank could cause
it to explode or burst. To protect from over-pressurizing, the compressor
is equipped with a factory preset safety valve. Do not remove, make
adjustments to or substitutions for this valve. Perform a test of the valve
from time to time: pull the ring on the valve to make sure that it operates
freely. If the valve does not operate freely, replace it before further use.
Never weld to, drill into, or change the air receiver in any way.
5. TAMPERING:
If any of the components above are found to have been
changed or tampered with, the warranty will be made void. When servicing,
we recommend using only identical replacement parts and any replacement
parts used must have the same specification as the original equipment.
SPECIFICATIONS
Specifications of your 1-1/2 HP air compressor:
Light weight: 22 lbs (10 kg)
Oil lubricated for durability and long life.
Extremely quiet operation
Includes air line regulator & gauge- set your exact line pressure (may require
attachment to compressor)
Oil breather cap (may require attachment to compressor)
115 volt, 60 hz, 8 amps
3400 RPM
2.5 CFM @ 90 PSI
Maximum pressure: 115 PSI
Lubrication oil: SAE20 or SAE30 weight non-detergent oil
COMPRESSED AIR CAUTIONS
