22
PBN5018
b
E
N
G
L
IS
h
23
!
!
!
Check the operation of the safety contact trip mechanism before each use.
It must move freely without binding through its entire travel distance. The
safety spring must return the contact to its fully extended position after being
depressed.
WARNING:
Do not use the tool unless both the trigger and the safety contact trip
mechanism are functional.
Do not use if the tool is leaking air or needs any other repair.
Personal injury may occur.
CONNECTING ThE TOOL
Turn the compressor on and set the regulator to proper pressure for the size and type
of fasteners being used.
After reading and understanding this entire manual, connect tool to air supply.
CAUTION:
Keep the tool pointed away from yourself and others at all times.
Do not load fasteners with safety or trigger depressed.
Always wear approved safety glasses and hearing protection when
preparing or operating this tool.
Never use a tool that leaks air or needs repair.
LOADING ThE FASTENERS
1. Connect the tool to the air supply BEFORE loading fasteners to prevent
fasteners from firing during connection. The fastener driving mechanism
may cycle when the tool is connected to the air supply.
2. Depress the magazine lock (
G, fig.4
) to release the sliding magazine (
H,
fig.4
) and pull it out fully as shown in the figure.
3. Place a full stick of the desired type and size of fasteners point down on
the bottom rail of the fixed magazine (
E, fig.4
). Up to 100 fasteners can be
loaded in the magazine.
4. Push the movable magazine forward until the lock clicks and locks it.
5. The tool is ready to operate.
OPERATING ThE TOOL
1. The depth to which a fastener is driven is determined by the supplied
air pressure. Test fire a fastener into a sample of the material you will be
working on and check depth. If a change is desired, adjust the regulator
to supply air at a higher or lower pressure. Test fire another fastener and
check depth again. Adjust as necessary. Do not exceed 110 PSI at the tool
or durability of the tool will be reduced.
CAUTION:
Keep tool pointed in a safe direction at all times.
Never attempt to drive fasteners into materials too hard to penetrate, or at
too steep an angle, or too near the edge of the workpiece. The fastener
can ricochet causing personal injury.
Disconnect tool from air supply before doing any
disassembly,
maintenance, clearing a jammmed fastener, leaving the work area,
moving the tool to another location, or handing the tool to another person.
Clean and inspect the tool daily. Carefully check for proper operation of
trigger and safety mechanism. Do not use the tool unless both the trigger
and the safety mechanism are functional, or if the tool is leaking air or
needs any other repair.
OPERATING PROCEDURES
fig.4
G
E
H
Summary of Contents for PBN5018
