OPERATION
•
The Pre-Amplifier allows the use of a magnetic stereo phono cartridge with an
amplifier that does not have a dedicated phono input.
•
The Pre-Amplifier has RIAA compensation designed for low noise.
•
Connect the turntable output leads to the L and R input RCA sockets on the pre-
amplifier.
•
Connect the pre-amplifier L and R outputs to the L and R input (Aux/CD/Tuner) on
an amplifier and select that input.
•
Switch the power on with the slide switch on the end of the unit.
•
If unused for long periods turn the power off to prolong battery life. For very long
periods, remove the battery.
NOTE:
if the sound quality deteriorates the battery may require changing.
•
To change the battery remove the screws and unclip the cover.
•
Disconnect the power connector from the old battery and replace it with a new one
reconnecting the power lead, noting the polarity.
OVERVIEW
CLEANING & MAINTENANCE
•
Clean the casing with a soft cloth lightly moistened with a mild detergent.
•
Never use any abrasive or solvents.
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL & ELECTRONIC
EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic Equipment (WEEE).
Any WEEE marked products must not be mixed with general household waste, but kept separate for the treatment,
recovery and recycling of the materials used. Contact your local authority for details of recycling schemes in your area.
Made in Taiwan
PR2 9PP
Man Rev 1.0
SPECIFICATIONS
Connections
Standard RCA Stereo L and R sockets
Input Impedance
50k ohms
Amplitude Gain
34dB
Rated Input Level
3mV (Max 38mV)
Output Level
1.8V RMS
Frequency Response
30Hz - 20kHz +/- 1dB
Compensation
RIAA with deviation <+/-1dB
S/N Ratio
50dB with normal input
Crosstalk
Better than 50dB
Current Drain
1mA average
Battery Type
9VDC PP9
