SAFETY
1.0
All Info Copyright © Pro Spot International Inc.
5
1.1 SAFETY & ENVIRONMENTAL SPECIFICATIONS
The Hybrid Spot welder is designed for indoor use.
The Hybrid Spot Welder is designed to operate from 10° C to 40° C.
Do not operate the unit on a slope of more than 10°.
1.3 WARNINGS AND IMPORTANT NOTICES
The following types of safety signs are used on the equipment and in Pro Spot’s instruction manuals:
Caution.
Read Instruction Manual.
Prohibited.
Prohibits behaviour that can cause
injury.
Command.
Calls for a specific action.
Warning.
Notice of personal injury risk and or
damage to equipment.
Warning.
Some parts of the welder may become hot
long after prolonged use.
Attention!
Lire Mode d’Emploi.
Interdit.
Interdit aux comportements qui peuvent
provoquer des blessures.
Commande.
Appelle a une action spécifique.
Avertissement.
Avis de risque de blessure personnelle et /
ou d’endommager l’équipement.
Avertissement.
Certaines parties du soudeur peuvent devenir
chaudes aprés une utilisation prolongée.
1.2 GENERAL
The Hybrid Spot welder has been designed and is tested to meet strict safety requirements. Please read the
following instruction carefully before operating the unit and refer to them as needed to ensure the continued
safe operation of the welder.
Information provided in this manual describes the suggested best working practices and should in no way
take precedence over individual responsibilities or local regulations.
The Hybrid Spot Welder is designed to comply with all applicable safety regulations for this type of equip-
ment. During operation, it is always each individual’s responsibility to consider:
• Their own and other’s personal safety.
• The safety of the welder through correct use of the equipment in accordance with the descriptions and
instructions provided in this manual.
READ BEFORE OPERATING WELDER!
Connect all 4 cables to negative
battery terminals Before using.
To access terminals, open right
side cover.
(The four cables to the negative battery terminals are
disconnected during shipping.)
OPEN CIRCUIT VOLTAGE AS IT RELATES TO STATE OF CHARGE
Open Circuit Voltage*
State of Charge
12.80 or greater.............................100%
12.60..................................75%
12.30..................................50%
12.00..................................25%
12.00....................................0
* The actual stabilized OCV can only be determined after the
battery has been disconnected from the charger for 24 hours.
KEEP OUT OF REACH OF CHILDREN
DANGER/POISON
NO
SPARKS
FLAMES
SMOKING
FLUSH EYES
IMMEDIATELY
WITH WATER.
SULFURIC
ACID
CAN
CAUSE
BLINDNESS OR
SEVERE BURNS.
GET
MEDICAL
HELP FAST.
SHIELD
EYES.
EXPLOSIVE
GASES CAN
CAUSE BLINDNESS
OR INJURY.
Battery Warnings
