2
(a)
Wiring for ONE Winch Kit
(Page 10,
Figure 4
) Extend the magnet wires on the Winch Kit to
the Curtain-Minder using 18-gauge lamp cord. Connect the other end of the lamp cord to the
bottom screw labeled
Magnet 1
and the top screw labeled
Magnet 4
. The reed switch wires should
be wired to the Normally Closed circuit on an alarm such as our MARK 220.
(b)
Series Wiring for TWO Winch Kits
(Page 10,
Figure 5
) Extend the magnet wires on two
Winch Kits using 18-gauge lamp cord. Connect one wire from each Winch Kit together. The other
end connects to the bottom screw labeled
Magnet 1
and the top screw labeled
Magnet 4
.
(c)
Series Wiring for THREE Winch Kits
(Page 11,
Figure 6
) Extend the magnet wires on three
Winch Kits using 18-gauge lamp cord. Connect one wire from each Winch Kit together. A wire
from the 1
st
Winch Kit connects to the bottom screw labeled
Magnet 1
and a wire from the 3
rd
Winch Kit connects to the top screw labeled
Magnet 4
.
(d)
Series Wiring for FOUR Winch Kits
(Page 11,
Figure 7
) Extend the magnet wires on four
Winch Kits using18-gauge lamp cord. Connect one wire from each Winch Kit together. A wire
from the 1
st
Winch Kit connects to the bottom screw labeled
Magnet 1
and a wire from the 4
th
Winch Kit connects to the top screw labeled
Magnet 4
.
NOTE
: A warning label is included with each winch kit. For safety, attach it near the curtain
winch. Being near the winch can be very hazardous, so STAY CLEAR!
7- The
CM 5000D
has a relay with a dry contact that can be tied to your alarm to tell you when the
unit has detected low power. There are three terminals at the top of the board (see Figure 3) for this
output. The alarm can be wired
N
ormally
O
pen
(NO)
or
N
ormally
C
losed
(NC)
.
8- Remove the green paper from the double-sided tape in the back of the unit and set the battery on
the tape. Connect the 12-volt lead acid rechargeable battery to the
RED
and
BLACK
wires being
sure to observe polarity.
9- Close the unit, reconnect the power to the unit, set the desired time delay and you are ready to
connect the winch handles.
10- A very nice feature of the
CM 5000D
is that you can test the Curtain-Minder with a short time
delay. Set the timer knob to 1
and remove the power from the circuit being monitored. The
Low
Power/Timing
light should be blinking and the curtains should drop. After testing, be sure to set
the knob to your desired delay time and reconnect the winches.
NEW TO THE CM 5000D –
Please follow these suggested wiring instructions when you are using the
WK 1510
winch kit for
“
Automatic Tunnel Mode
.” We recommend using 4-conductor 18-22 gauge wire.
(1T)- Open the unit and set the DIP switch for the number of winches you are using. The DIP
switch is located on the left hand side of the board. Push the switch or switches up for each winch
being used. The switches on the next page show the selection for 1, 2, 3 or 4 winches.
