NJ1 el. & FREAK el. compact bike usage instructions
25
Figure 39: Body Contour seat cover
The
belt system
can be subsequently adjust-
ed. The slack of the seating surface can be
changed using fleece hook-and-loop straps.
Figure 40: Open belt system with fleece hook-and-
loop straps for adjusting the slack
For the “belt system” seating system:
when adjusting the slack of the belt system,
make sure that the slack does not protrude
beyond the lower edge of the frame. Otherwise
when overcoming obstacles, you may get
caught the belt system and your bottom that
may result in injury and damage to the belt
system. The product may not be operated with
damaged seating system.
Note:
Using a seat cushion on the seat system is
mandatory. At cold temperatures, the seat
cushion prevents lower abdomens from under-
cooling and protects against dirt and wetness.
Moreover, the cushion ensures uniform pres-
sure distribution for your bottom and absorbs
impacts as well as vibrations.
20 Neck rest
20.1 Neck rest height adjustment
The following instructions are intended
for and may only be carried out by a rehabilita-
tion specialist dealer or PRO ACTIV
To adjust the height of the neck rest, two M6
fixing screws (AF 5 mm) have be loosened on
the neck rest holding tube. Then the height of
the neck rest holding tube
can e adjusted.
Once the desired height has been found, the
two M6 fixing screws (AF 5 mm) are tightened
to 7 Nm again and secured using screw lock-
ing fluid.
Figure 41: Height adjustment of the neck rest via
two M6 fixing screws on the neck rest holding tube
20.2 Neck rest angle adjustment
The angle adjustment of the neck rest is car-
ried out via the clamp lever on the neck rest
holding tube. Open the quick release lever and
set the neck rest padding to the desired angle.
Then close the quick release lever again.
Figure 42: Quick release lever closed (view from
behind)
M6 clamp screw for
height adjustment
Quick release
lever closed
