NJ1 el. & FREAK el. compact bike usage instructions
30
Figure 57: Valve adapter and clamp lever of the
compressor
23 Adaptation and decoupling the
drive unit
23.1 Safety instructions
The adaptation and uncoupling of the
drive unit may only be performed when the
drive system is switched off in order to prevent
unintended drive signals.
The drive system may only be switched
on after completing the adaptation process.
The drive unit may only be adapted and
detached on dry, stable and flat surfaces.
23.2 Terminology
The product comprises drive unit and product
frame. The product frame is also designated as
chassis. The insertion shaft is located on the
adapter plate of the chassis.
Figure 58: Insertion shaft on the chassis adapter
plate
The insertion shaft – the counter item for the
insertion shaft – is located ont he adapter plate
of the drive unit.
Figure 59: Insertion maul of the drive unit adapter
plate
23.3 Adapting the drive unit
For adapting the drive unit to the chassis, first
operate the parking brake. Hang the insertion
maul of the drive unit adapter plate to the in-
sertion shaft of the chassis adapter plate. In
doing so, the drive shaft must be raised a little
to allow the insertion maul of the drive unit to
slip under the insertion shaft on the chassis.
Figure 60: Lifting the drive wheel
Insertion shaft
on the chassis
adapter plate
Insertion maul of the
drive unit adapter plate
Lift the
drive wheel
Valve adapter
Clamp lever