Operating instructions LITTY 4you
9
Figure 1: Adjusting the seat heights using the rotat-
ing points
If you need a greater adjustment range for the
seat heights, the
seat plate can be turned
over
(seat height adjustment approx. 3 cm). To
do this, undo the M6 fixing screws at the rota-
tion points (AF 4 mm) completely, remove the
seat plate and replace it turned upside down.
Please make sure that the straight edge re-
mains at the front. You can see the seat plate
in the high and low position in the following
figures. Afterwards, tighten the M6 fixing
screws on the rotation points (AF 4 mm) again
using 7 Nm torque.
Figure 2: Seat plate in high position, slots down
Figure 3: Seat plate in low position, slots up
Every time the seat heights and angles
are adjusted, the position of the footrest needs
adjusting as well. Make sure the clearance
under the footrest is sufficient. Experience
shows that this should not be less than 4 cm.
You will find more details in Chapter 16.5.
16.2 Back shell position
The angle of the back shell and its spacing
position from the seat plate can be adjusted by
undoing the four M5 fixing screws (AF 3 mm)
in the
mounting slots
. The associated nuts
(AF 5mm) must be tightened for this. For good
seating posture, we recommend positioning
the back shell vertically if possible.
Figure 4: Mounting slots on the back shell
You can get an even greater adjustment range
by completely undoing the M5 fixing screws
(AF 3 mm) and moving them in the
three des-
ignated boreholes
in the clothing guard. Make
sure that the position of the M5 fixing screws
on the right-hand and left-hand clothing guard
are identical.
Figure 5: Adjustment range for back shell on cloth-
ing guard
Boreholes for
back shell ad-
justment
Rotating the rotation points
positions (AF 6 mm)
M6 fixing screws
Rotation
points
M5 fixing screws
(rear) with nuts
