Operating instructions SPEEDY F1
12
18.1.4 Adjusting the backrest angle or
folding down the backrest with an
adjustable backrest
To
adjust the backrest angle
, relieve this
(otherwise there is a risk of tipping) and then
loosen the locking pin that engage in the
locking holes of the side section on the left and
right. For this purpose, grasp under the seat
upholstery and in the middle, pull the cord to
the front that is linked to the locking pin.
For safety reasons, the adjustment range of
the backrest is limited by a stop pin when
supplied. The stop pin allows a maximum
inclination of 7° to the rear from a vertical
position.
Figure 4: Adjustable and foldable backrest
Figure 5: Locking pin and stop pin (viewed from the
outside of the product)
Figure 6: Locking pin connected to the cord (bottom
view)
Figure 7: Cord for operating the locking pin and thus
for adjusting the angle of the backrest
If you have released both locking pins by
pulling on the cord, you can adjust the backrest
as desired and re-engage it by letting go of the
cord. In doing so, before applying load again,
make sure that both locking pins have
engaged safely into the desired locking holes
(the same position on the right and left).
Depending on the adjustment of the
backrest angle, check the tight engagement of
the backrest via the locking pins.
To
fold down the backrest
, pull on the middle
of the cord towards the front, and at the same
time, fold the backrest downwards until it rests
on the seating area. If you want to return the
backrest back to the desired angle, proceed as
described at the beginning.
Cord
Locking pin
Pull from the
middle to the
front
Locking pin
Stop pin
