Operating instructions SPEEDY F1
13
18.2 Adjustable back padding & their
adjustment options
The back system "Adjustable back padding"
comprises one belt system and one back
upholstery. The slack of the backrest can be
adapted to the individual requirements via the
belts with tensioning loops.
First remove the back upholstery that has been
covered over which has been attached using
hook-and-loop straps. The belt system located
underneath has been set in the factory that the
top and the bottom belts have a slack of
approx. 2 cm. The middle belts have been
pulled tight for a good lumbar support.
Figure 8: Belt system of the adaptable back padding
with three belts
To
adjust the slack in the belt system
, the
tensioning loops of the respective belt are held
on their strap and pressed (strongly) to the
right until the belt slackens.
Figure 9: Push the tensioning loop onto its strap on
the right
Figure 10: Tensioning loop open completely
Now the belt can be pulled tight for setting a
small slack or loosened for a large slack (Fig.
11 and 12). The belt does not have to be
threaded out of the tensioning loops for this.
Figure 11: Reduce the slack
Figure 12: Increase the slack
In order to put the tensioning loops back onto
the back system loosely again, pull the loop
section at the back to the left. You should dose
your pulling force with care in order not to
adjust the set slack again.
Top belt
Bottom belt
Middle belt
Pull to the right:
Increase the slack
Tensioning loop with strap
Press to
the right
Pull the rear loop part to the left:
Reduce the slack
