Operating instructions SPEEDY F1
24
Figure 51: Foot support with "Box shape" footrest
from below
22.2 Foot support continuous
Figure 52: Foot support with footplate "Tipped
forward" throughout
Figure 53: Foot support with "Box shape" footplate
throughout
For the
longitudinal setting of the footrest
support tubes or adaptation to the lower leg
length
, the M6 fixing screws (AF 4 mm) must
be undone on both sides on the outside of the
frame tube. The footrest support tubes are
then pushed along their slots and thus brought
into the correct position. Observe that the
footrest support tubes are both the same
length on both sides after they have been
adjusted.
Figure 54: M6 fixing screw with washer and slot in
footrest support tube for adjusting the lower leg
length
Once the position has been set, fix the footrest
support tubes by tightening the M6 fixing
screws (AF 4 mm) with washers to 7 Nm on
both sides.
Ensure when setting the lower leg length,
that no strong pressure is produced between
the underneath of the lower leg of the
wheelchair user and the edge of the seating
system.
With a product frame that has a larger
lower leg width at the top than the bottom, due
to the resulting tensioning of the footrest
support tubes in the footrest support plate from
the longitudinal setting, it is necessary to open
the M6 fastening clamp screws (AF 5 mm)
again on the footrest support plate. View the
procedure in chapter 22.1.
M6 fixing screw
with washer
Slots in the
support
tube
Footplate
Footrest
support
plate
M6 fastening
clamp screws
