Usage instructions SPEEDY F4 & F2
40
Figure 105: Footplate support raised from the
bracket (product view from the front)
Figure 106: Footrest folded up on one side (product
view from the front)
When you fold the footrest back down, take
care that the recesses are resting accurately at
the back and front on the cylinder pins of the
bracket.
Figure 107: Cylinder pin and corresponding recess-
es
For the
longitudinal setting of the footrest
support tubes or adaptation to the lower leg
length
, the M6 fixing screws (AF 10 mm) must
be undone on both sides on the outside of the
frame tube. The footrest support tubes are
then pushed along their slots and thus brought
into the correct position. Observe that the foot-
rest support tubes are both the same length on
both sides after they have been adjusted.
Figure 108: M6 fixing screw with washer and slot in
footrest support tube for adjusting the lower leg
length
Once the position has been set, fix the footrest
support tubes by tightening the M6 fixing
screws (AF 10 mm) with washers to 7 Nm on
both sides.
Fold-up on
one side
Bracket with
cylinder pin
Recesses
M6 fixing
screw
with
washer
Bracket with cylinder pin
Slots in the
support tube
