Usage instructions SPEEDY F4 and F2
61
27.3 Marking
Wheelchairs tested according to ISO 7176-19
and approved for transporting passengers in
motor vehicles are marked with the following
karabiner symbol:
Figure 181: Karabiner symbol/sticker for a tested
wheelchair approved for transporting passengers in
motor vehicles
27.4 Fastening the wheelchair in the
vehicle
Information on the fastening points is listed
below. A transport restraint system is not
available for these wheelchair models.
The fastening points for loops are marked with
the above described karabiner symbol. The
wheelchair restraint system fasteners must be
fastened exclusively in the marked locations
and must always be attached symmetrically on
both sides of the wheelchair. The following
figures show how the system is fastened on
one side of the product.
Figure 182: Symbol for front fastening and wheel-
chair loop at the front
Figure 183: Symbol for rear fastening and wheel-
chair loop at the rear
27.5 Handling instructions and posi-
tioning the wheelchair in the vehi-
cle
The crash test according to ISO 7176-19 de-
mands a frontal impact at 48 kph and therefore
represents only a part of the possible hazard-
ous situations. Basically, all passengers must
be seated on a standard vehicle seat with
three-point seat belt. This is the safest possibil-
ity of transportation. If this cannot be imple-
mented, the wheelchair as well as the passen-
ger must be secured. The use of this retention
system must be observed in the following
guidelines and safety instructions.
The wheelchair must only be transported
in the direction of travel in the vehicle, as it was
tested facing forwards in the direction of travel
according to ISO 7176-19.
Figure 184: Incorrect positioning of the wheelchair in
the vehicle
