TRAVELER 4all Ergo & 4you Ergo usage instructions
14
itself together a little. Moreover, by active shak-
ing and shifting your weight alternately to the
right and left and by pressing on the handrims
at the same time, the product's size is reduced
even more.
Lock the folding mechanism again after you
have passed through narrow space (chapter
17.1). The seat cover must be relieved for this
purpose.
17.3 Safety instructions
After passing through narrow space (fold-
ing in) and before using the product after being
folded together, the folding mechanism must
be properly locked again (chapter 17.1), oth-
erwise the backrest and the footrest will have
lateral play.
Sand, dirt and salt may make the folding
mechanism sluggish or render it inoperable.
For this reason, make sure that is cleaned
regularly according to chapter 32.
If the folding mechanism has jammed or
does not function correctly, you should contact
your rehabilitation specialist retailer or
PRO ACTIV before using it again.
18 Individual setting options
The following instructions are intended
for and may only be carried out by a rehabilita-
tion specialist dealer or PRO ACTIV
18.1 Adapting the seat height at the
back
The product is equipped with an wheel plate
that permits seat height adjustment in steps of
1 cm.
Figure 6: Wheel plate for rear seat height adjust-
ment (drive wheel removed)
To adjust the seat height, first remove the drive
wheels using the quick-release axles (see
Chapter 22.1) and turn the product over so that
you have direct access to the wheel plates.
Then proceed as follows:
1. Open the aluminium locking nuts (AF
41 mm) on both sides and keep turning
them out on the drive wheel bushings until
the position gate positioned underneath it
can be pushed out of the wheel plates onto
the drive wheel bushings.
Figure 7: Aluminium locking nuts and drive wheel
bushing (view from outer side of product)
Figure 8: Position gate (view from outer side of
product)
Drive wheel bushing
Aluminium locking nuts
Position gate
Wheel plate
