TRAVELER 4all Ergo & 4you Ergo usage instructions
15
Figure 9: Different position gates depending on the
equipment of the product and user weight
Figure 10: Aluminium locking nut released and posi-
tion gate pushed towards aluminium locking nut
(view from outer side of product)
2. Position the axle tube at the desired and
equal height on both sides and fix the axle
tube in this position by pushing the position
gates on the right and left sides to the
corresponding height position of the wheel
plates.
Figure 11: Axle tube fixed in position with position
gate (view from outer side of product)
3. Position the aluminium locking nuts back
on the drive wheel bushings so that they
rest slightly against the position gates, and
then set the drive wheel track correctly
(see Chapter 22.2).
18.1.1 General instructions
When changing the rear seat height each time:
the wheel track of the drive wheels must
be checked and readjusted if necessary
(see Chapter 22.2).
the brakes must be readjusted
(see Chapter 26).
the caster wheel axles must be readjusted
(see Chapter23.4).
the backrest angle may have to be reposi-
tioned (see chapter 19.1.3).
make sure that there is sufficient ground
clearance under the footrest. Experience
shows that this should not be less than
4 cm (see Chapter 24).
if necessary, the height of the anti-tipping
support may have to be readjusted
(see chapter 25.3).
Position gate pushed towards
aluminium locking nut
