TRAVELER 4all Ergo & 4you Ergo usage instructions
22
Figure 27: Belt system of the adaptable backrest
upholstery with three belts
Figure 28: Belt system of the adaptable backrest
upholstery with four belts
To
adjust the slack in the belt system
, the
tensioning loop of the respective belt is held by
its strap and pressed to the right until the belt
slackens.
Figure 29: Push the tensioning loop onto its strap on
the right
Figure 30: Tensioning loop open completely
Now the belt can be pulled tight for setting a
small slack or loosened for a large slack
(Fig. 31 and 32). The belt does not have to be
threaded out of the tensioning loops for this.
Figure 31: Reduce the slack
Figure 32: Increase the slack
In order to put the tensioning loops back onto
the back system loosely again, pull the loop
section at the back to the left. You should dose
your pulling force with care in order not to ad-
just the set slack again.
Top belt
Bottom belt
Middle belt
Pull to the right:
Increase the slack
Tensioning loop with strap
Press to the
right
Pull the rear loop part to the left:
Reduce the slack
Top belt
Bottom belt
Middle belts
